2-pack Etch Primer 0.5L

Characteristics

Surface Preparation

• Degrease, then sand with coarse paper (no. 80). Possibly sandblast or sandblast. After sanding, absolutely do not wash with water, detergents, acids or general solvents. 
• Before and after any sanding operation, the substrate must be thoroughly degreased using a Grease Remover to remove all traces of dirt, oil, grease, silicone, wax etc. Afterwards, clean thoroughly with a dry, clean cloth.
  

Mixing Ratio by Volume

• 1:1
• Part A & Part B quantity may not be 250ml  (typically more) so always Mix by Volume in a beaker or similar

Application

• Apply 1 - 2 wet, even coats
• Allow 3 - 10 minutes between coats at 25°C
  

Drying Times

Notes

• Do not apply at temperatures less than 10°C, when the relative humidity exceeds 80%, or if the surface temperature is within 3°C of the dew point.
• Drying times can vary depending on temperature, flash off between coats, film builds and number of coats applied.

*Allow 30 minimum to 12 hours maximum drying time before re-coating. Recommendations are based on 25°C ambient temperature.

Suggestions

• NEVER use acids to descale or clean surfaces before application.
• Do not use detergents, dirty solvents, water to wash surfaces after sanding. Use a wax & grease remover then clean thoroughly with a dry, clean cloth.
• Do not touch the surfaces with bare hands before application.
• Mix very carefully before use. 
• To obtain an excellent result, the preparation of the surface is clean, without grease, dust or other dirt (even fingerprints), sweat or traces of solvents or water).

Safety & Environment

Please observe the precautions written on the container or for more detailed information consult the product safety data sheet. Use appropriate personal protective equipment.

For disposal, use the appropriate containers usually present in the storage location or ask the site managers. Dispose of according to current regulations.